OWC Multi-Mount Installationshandbuch PDF herunterladen (Seite 23)

To install a 2.5” Drive into the OWC Multi-Mount, place the 2.5” drive

mechanism on the table in front of you, with the interface connection to

the right side.

Take the OWC Multi-Mount 2.5” drive bracket that has the white OWC

silkscreen on it, and attach it to the drive mechanism as shown above,

with the portion of the bracket that has the OWC logo extended o of

the drive to the left.

Firmly tighten the large Phillips screws that are held to the OWC Multi-

Mount bracket through vibration isolation rubber grommets to the side

of the hard drive facing you.

Once attached, rotate the drive around and repeat using the other drive

bracket. Make certain that all screws are rmly inserted into the drive.

The OWC 2.5” Multi-Mount is now ready to install into a 3.5” drive bay, or

into the OWC 3.5” Multi-Mount.

OWC Multi-Mount Chapter 5 - Bracket Assembly

5.2 Installing a 2.5” Hard Disk Drive

5 OWC MULTI-MOUNT ASSEMBLY

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Keine Kommentare

OWC Multi-Mount Installationshandbuch Seite 23