OWC Multi-Mount Installationshandbuch PDF herunterladen (Seite 21)

5.1 Installing either 1 or 2 3.5” Hard Disk Drives

Begin by positioning the bottom 3.5” hard disk drive with the con-

nection ports facing away from you, and then pick up the OWC Multi-

Mount 3.5” drive bracket that has the white OWC Multi-Mount 3.5”

silkscreening on it.

Place the OWC Multi-Mount onto the bottom 3.5” hard disk drive using

the center Phillips screw - coarse thread - and don’t tighten it all the way

yet. Leave it loose.

Attach a second screw to one of the outside holes, that will make sure

that you have the bracket centered on the hard disk drive. Then, you can

insert the third screw and tighten all 3 of them rmly.

If you are going to install a 2nd 3.5” drive in the OWC Multi-Mount, con-

tinue with installation of that drive now following the same instructions.

You do not have to install 2 drives into the bracket and can add a 2nd

drive at any time.

NOTE: Installation of a 2nd 3.5” Drive requires the removal of your opti-

cal drive due to height restrictions.

OWC Multi-Mount Chapter 5 - Bracket Assembly

5 OWC MULTI-MOUNT ASSEMBLY

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Keine Kommentare

OWC Multi-Mount Installationshandbuch Seite 21